Delta HES Series User Manual page 78

Start-up display selection
Control mode VF FOCPG
Settings
This parameter is used to set the contents of the start-up screen. The content of the
user-defined option is displayed in accordance with the setting value of Parameter 00-04.
Slave reverse operation for depressurization
VF FOCPG
Control mode
Settings
This parameter setting is required only for the Slave but not needed for the Master.
When the parameter is set as 1, it is necessary to make sure that the outlet end of the Slave is
not installed with any one-way valve and the parameter 03-16 is set as 500.
FOCPM
0: F (frequency command)
1: H (actual frequency)
2: Multi-function display (user-defined 00-04)
3: A (Output current)
FOCPM
0: Disabled
1: Enabled
4-35
Chapter 4 Parameter Functions
Factory default: 0
Factory default: 0
|HES Series