Chapter 3 Start Up - Delta HES Series User Manual

3-1 Description of Control Panel
3-2 Adjustment Flow Chart
3-3 Explanations for the Adjustment Steps
Please verify again before operation that the wiring is done correctly, especially that
the output terminals U/T1, V/T2, and W/T3 of the Hybrid Servo Controller cannot
have any power input. Make sure that the ground terminal
correctly.
Do NOT operate the AC motor drive with humid hands.
Check for loose terminals, connectors or screws.
Make sure that the front cover is well installed before applying power.
In case of abnormal operation of the Hybrid Servo Controller and the associated
servo motor, stop the operation immediately and refer to "Troubleshooting" to check
the causes of anomalies. After the output of the Hybrid Servo Controller is stopped,
when the power terminals L1/R, L2/S, and L3/T of the main circuit are still
connected, touching the output terminals U/T1, V/T2, and W/T3 of the Hybrid Servo
Controller may lead to electric shock.
Chapter 3 Flow of machine Adjustment|HES Series

Chapter 3 Start Up

3-1
is connected