Table of Contents
Advertisement
User's Manual
4. MEASUREMENTS
4.1. Measurement mode control - the START key
Beginning, process and ending of measurements is controlled by the START key.
1
2
1
2
4.1.1. Measurement mode
The instrument enables to accomplish measurements in following three modes:
• One measuring cycle – after the START key is pressed and released, one measuring
cycle starts and it is completed after few seconds. The result of measurement is displayed.
• Continuous measurement – press the START key; measurement is in progress and
current measured values are displayed until the START key is released.
Copyright © 2006–2019 ILLKO, s.r.o.
ST ART
ST ART S T ART
ST ART
ST ART S T ART
ST ART
ST ART S T ART
Ca l
LO C K
ST ART
ST ART
ST ART S T ART
P ,S
H OLD
One measuring cycle
One measuring cycle starts an it is
Continuous measurement
Measurement is in progress until
the START key is released.
Locking of measurement
Measurement continues though
both keys are released.
Ending of measurement.
Holding of displayed data
Measurement is in progress and
displayed result is periodically
Measurement is in progress and last
displayed result is displayed.
To cancel the HOLD mode press
START
and release the [HOLD] key again.
Fig. 2 – Measurement mode control
13
REVEXplus, REVEXplus USB
completed.
updated.
Advertisement
Table of Contents
