OVMS User Manual page 56

OVMS: Renault Twizy User Guide
Command
CFG LOAD [slot#]
CFG INFO
CFG RESET [slot#]
Function
Load a profile slot into the current working set.
slot#: 0..3, 0=factory default config, 1..3=custom profile
If you omit the slot number, the command will reload the current
profile from the last save (or defaults), thus discarding any
changes made to the working set.
The profile loaded from EEPROM will be checked for
consistency using a checksum. If the check fails all parameters
will be reset to defaults.
Loading will clear the modification flag (see console) and switch
the selected profile accordingly.
Important: (see above) a full profile switch can only be done if the
Twizy is not moving and not in "GO" mode. I.e. after switch-on,
before "ignition". The command response will inform you if the
switch was partial.
A partial switch can be done any time, it only covers DRIVE,
RECUP, RAMPS and SMOOTH configurations.
Output currently active profile slot# and working set parameters
for these commands:
SPEED, POWER, DRIVE, RECUP, RAMPS, SMOOTH
V3.7:
slot# = 1..3: reset EEPROM profile directly
else: reset working set & try to apply to SEVCON
Additional note: this macro command will not switch to profile
slot #0, only the current working set will be reset. An offline reset
using the D/R buttons has the same effect.
Issue a RESET to begin a new profile configuration from scratch.
56 / 77
2019/05/02 RT3.9.1