OVMS User Manual page 47

OVMS: Renault Twizy User Guide
Command
CFG SPEED [max_kph]
[warn_kph]
CFG SPEED
Function
Set speed limit and warn level. Allowed value ranges:
max_kph: 6..138, default 80 (T45: 45)
warn_kph: 6..138, default 89 (T45: 56)
Both parameters can be omitted, the command will then use their
defaults. Warn level may be lower than max speed, usable for
example to avoid speeding tickets.
V3.3: The reverse speed will also be limited, but only up to the
default reverse speed (~10 kph).
NOTE: this command will need to go pre-operational, so the
vehicle needs to be stopped. Also a power cycle should be done
after using this command.
Since V3.8.3, the maximum speed will also be set in operational
mode ("GO") when loading a profile, using the same mechanism
as for LOCK & VALET mode. This allows to reduce speed
temporarily, but should not be used to set speeds exceeding the
configured power map.
Reset speed configuration to default.
NOTE: this command will need to go pre-operational, so the
vehicle needs to be stopped. Also a power cycle should be done
after using this command.
47 / 77
2019/05/02 RT3.9.1