Protección del cables de alimentación • Los cables de alimentación eléctrica se deben protección aislante, que puedan encontrarse dentro use. In no event will Extron Electronics be liable for direct, indirect, or consequential instalar en lugares donde no sean pisados ni apretados por objetos que se puedan de la caja o alojamiento del producto, y que puedan apoyar sobre ellos.
Page 4
The output can be extended with Extron MHR cables up to 250' in length (XGA resolution signal). The P/2 DA2xi routes all video ID bits to its local monitor output to allow for automatic resolution selection by DDC1 and DDC2 (plug and play cards and projector).
Installation and service must be performed by illustration. authorized personnel only. Remove the feet from the bottom of the P/2 DA2xi, if they The 1" high, quarter rack width P/2 DA2xi can be placed on are installed. a tabletop, mounted on a rack shelf, mounted under a desk or Mount the unit using two 4-40 x 3/16"...
Under-furniture mounting other furniture using an optional Extron MBD 129 through-desk The P/2 DA2xi can be mounted under a table or other mounting kit, part #70-077-02. Mount the P/2 DA2xi through a horizontal surface using an optional Extron MBU 125 under- desk or table, as follows: desk mounting kit (part #70-077-01).
Mark the four screw holes on the inside of the surface to which you are Follow these steps to mount the P/2 DA2xi on the PMK 350 mounting the device. bracket as follows: Drill four pilot holes, each 3/32"...
Cabling BNC Connections careful to observe the correct polarity. See Power supply wiring in Use an Extron SY adapter to connect the P/2 DA2xi's the following section for wiring instructions. 15 HD VGA output to a display device's 5 BNC connectors.
Use the supplied tie-wrap to strap the power cord to the extended tail of the connector. Your P/2 DA2xi may have shipped with a blue captive screw connector. This blue connector can be plugged into either a blue or an orange power receptacle.
Need help?
Do you have a question about the P/2 DA2xi and is the answer not in the manual?
Questions and answers