Extron electronics P/2 DA2 WM F Setup Manual

Setup Guide — P/2 DA2 WM F, WM F AAP, EC F, D
This guide provides basic instructions for an experienced
installer to set up and operate the Extron
P/2 DA2 WM F, WM F AAP, EC F, D Series of
distribution amplifiers.

Installation

These distribution amplifiers are high performance one input, two output video devices with
audio that accept video input from a VGA-QXGA compatible PC and distributes that signal to
separately buffered outputs. Refer to the user manual for specific mounting instructions. An
example application for the P/2 DA2 D is shown below. Refer to the user manual for other
application and installation examples.
Extron
MHR-5 Cable
Extron
P/2 DA2 D
Distribution Amplifier
C
Step 1 — Power down
Power off the display device, the PC and its local monitor.
Step 2 — Connect inputs
• For video input, connect the VGA output of the PC to the Input or Computer In 15-pin
HD connector on the faceplate of the distribution amplifier.
• For unbalanced stereo audio input, connect the input device
to the 3.5 mm female audio jack on the faceplate of the
distribution amplifier. Wire the audio plug as shown on the
right.
Step 3 — Connect outputs
• If a local monitor is being used, connect the monitor of the PC to the Buffered Local
Monitor or Monitor Out 15-pin HD output connector on the faceplate of the distribution
amplifier.
Projector
Audio
Installation and service must be performed by authorized personnel only.
®
2
1 2
A
M P S
U T
R S
T P K E
O U E A
S P
m s
R
O h
4 /8
L
U S
C T E
S M O
U T
R E
I N P
E
V U T
1 0
L /M
V O
R
L
L
R
W E
P O
Extron
R
X .
1 2 V
M A
3 A MPA 122
Mini Power Amplifier
Audio
Output
PC w/ Audio
Extron
SI 3CT LP
Full-Range Ceiling
Speakers
Tip (L)
Ring (R)
Sleeve ( )
(Continued on reverse side)