Section 4: Operations; Operation Overview - Grizzly T28780 Owner's Manual

SECTION 4: OPERATIONS

Operation Overview

To reduce your risk of
serious injury, read this
entire
using machine.
Eye injuries, respiratory problems, or hear-
ing loss can occur while operating this
tool. Wear personal protective equipment to
reduce your risk from these hazards.
Keep hair, clothing, and
jewelry away from mov-
ing parts at all times.
Entanglement can result
in death, amputation, or
severe crushing injuries!
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model T28780 T28781 (Mfd. Since 06/19)
manual BEFORE
To complete a typical operation, the operator
does the following:
1.
Examines workpiece to make sure it is suit-
able for cutting.
2.
Adjusts fences close to the bit for maximum
workpiece support, then secures fences in
place.
3. Adjusts bit height for desired cutting
profile.
4.
Adjusts fence position to establish depth of
cut and makes sure that it is parallel with the
table T-slot.
5. Wears safety glasses and a respirator.
Locates push sticks or blocks if needed.
6.
Verifies direction of router bit rotation is cor-
rect for operation, then starts router.
IMPORTANT: For small or odd-shaped
workpieces, a zero-clearance fence or jig is
used.
7. Holds workpiece firmly and flatly against table
and fence, then pushes workpiece into bit at
a steady and controlled rate until workpiece
moves completely beyond router bit.
WARNING: Keep workpiece firmly against
table and fence, and keep hands away from
spinning router bit during entire cut.
8. Stops router once operation is complete.
-29-