Table of Contents
Advertisement
To test run router table:
1.
Clear all setup tools away from router table.
2.
Make sure router table paddle switch is set to
OFF position.
3.
Make sure router power cord is plugged into
receptacle in router table electrical box.
4.
Connect router table power cord to power
supply.
5.
Reach into dust box and turn router ON.
6.
Using paddle switch, turn router table ON,
verify router powers up, and then turn router
table OFF.
7.
Remove switch-disabling key, as shown in
Figure 41.
Figure 41. Removing switch key from paddle
switch.
-28-
8.
Try to start router with paddle switch. The
router should not start.
—If router does not start, switch disabling
feature is working as designed.
— If router does start, immediately stop
router. The switch disabling feature is
not working correctly. This safety feature
must work properly before proceeding with
regular operations. See Troubleshooting
for help.
9.
Re-install switch-disabling key in paddle
switch.
Congratulations! The test run is complete.
The router table is ready for operation.
Model T28780 T28781 (Mfd. Since 06/19)
Advertisement
Table of Contents
