Table of Contents
Advertisement
SECTION 6: OPERATIONS
Before Routing
Your safety is important! Please follow the
warnings below during this entire section:
To avoid serious personal injury, read and
become familiar with the entire instruction
manual before using the Model G0528.
Damage to your eyes, lungs, and ears
could result from failure to wear safety
glasses, a respirator, and hearing protec-
tion while using this machine.
-18-
Loose hair and cloth-
ing could get caught in
machinery and cause
serious personal inju-
ry. Keep loose clothing
rolled up and long hair
tied up and away from
machinery.
Routing
Routing operations on your Model G0528 are
grouped into three main techniques:
• Jointing an edge (page 18)
• Groove cutting (page 19)
• Profile cutting (page 19)
Jointing an edge:
Jointing the edge of a board involves using a
straight cutting router bit to remove wood from the
edge face of a board. The result is a perfectly flat
and square edge.
1.
Secure a straight cutting router bit into your
router according to the router manufacturer's
instructions.
2.
Snap the smallest table insert into the
recessed hole that still allows the router bit
to freely rotate.
3.
Adjust the outfeed fence even with the left
edge of the router bit (Figure 16).
Figure 16. Jointing setup.
(Top View)
G0528 Sliding Router Table
Advertisement
Table of Contents
