Grizzly T28780 Owner's Manual page 24

13. Install (2)
⁄ -20 x ⁄
1 3
4 4
ter slot of infeed fence (see Figure 21).
Infeed Fence
Carriage Bolts
Figure 21. Carriage bolts installed in infeed
fence.
14. Align carriage bolts with vertical slots in fence
base and install infeed fence (see Figure 22).
Vertical Slots
Carriage Bolts
Infeed Fence
Figure 22. Infeed fence installed on fence base.
15. Secure infeed fence to base with (4)
flat washers and (4)
Figure 23).
Knobs & Flat Washers
(2 of 4)
Figure 23. Infeed fence secured to base.
-22-
carriage bolts in the cen-
x 2
Fence Base
⁄
1
⁄ -20 steel knobs (see
1
4
Fence
16. Repeat Steps 13-15 to install outfeed fence
on opposite side of base.
17. Align (2) holes in fence base with slots in
table. Insert (2)
24) through table and fence base, as shown
below.
Note: Ensure T-bolts sit flush in T-slots
underneath the table.
Fence
Base
Figure 24. T-bolts inserted through table and
18. Assemble (2) fence locks (see Figure 25)
by removing one ball knob on each handle,
sliding it through hole at top of shaft, then re-
installing knob.
19. Install (1)
(see Figure 25) on each T-bolt installed in
Step 17.
"
4
Figure 25. Fence locks installed.
Model T28780 T28781 (Mfd. Since 06/19)
⁄ -18 T-bolts (see Figure
5
16
T-Bolt
fence base.
⁄ " flat washer and (1) fence lock
5
16
Handle
x 2
Ball
Knob
Shaft
Washer