The Configuration for a WLAN connection
Setting the parameters for a
wireless network
Selecting and connecting a WLAN by hand
Searching for and Selecting
the Network
Entering the Password (for
encoded networks)
Storing Network Settings
and Restarting
Check that there is no cable connected to the LAN socket of the
SDV 3100 HV.
Connect one of the WLAN aerials from the accessories enclosed to the
WLAN socket.
Switch the SDV 3100 HV on, open the System Configuration menu by
pressing the
button on the remote control handset or the
front panel of the SDV 3100 HV.
Use the / buttons on the remote control handset to select
the menu point "Network", then confirm your choice with the
button.
Select under the menu item "Interface" the option "WLAN"
The following menu items are displayed for WLAN configuration:
First select the menu point "Scan for WLAN", and activate it by
pressing the button.
A list of the WLANs found is displayed on the screen.
Use the / buttons to select the WLAN to which you
wish the SDV 3100 HV to be connected, and confirm your choice
with the button.
If the network is encoded, the window shown below will appear once the
WLAN is selected.
At this point please enter the network passphrase and confirm your
input by pressing .
Select the "Store and exit?" point, and confirm your choice with
.
Finally select the "Store and exit?" menu point and press the button to
accept the settings.
If a WEP code is used, the password must be entered as a hexadecimal code
(0 - 9, A - F).
button on the
Possible
entries
59