Sony PCS-G70 Integration Manual page 50

For loading of application
1. Display the Service menu.
2. Insert the Memory Stick, in which the application
software of the version to be loaded is recorded, into
the Memory Stick slot.
3. Select "Load Application" using , ,
buttons on the remote commander and press the PUSH
ENTER button.
4. A confirmation message on whether to execute is
displayed.
5. To execute, select "OK" and press the PUSH ENTER
button. The screen display during loader execution
then appears. After completion, the launcher menu is
displayed. To cancel execution, select "Cancel" and
press the PUSH ENTER button. The current display
returns to the Service menu.
6. Push in the Memory Stick once and take out it.
n
Do not turn off the power or take out a Memory Stick until
the launcher menu is displayed.
For command input
1. Display the Service menu.
2. Select "Command" using , ,
remote commander and press the PUSH ENTER
button.
A key guidance is then displayed.
3. Enter the commands in a command list from the
remote commander.
m
. To set two or more commands, put a one-character
blank between the commands and then enter them.
. Set only one type of LAN interface. Otherwise, the
LAN interface does not operate normally.
. The validated command can be confirmed in a
command column at all times.
. Use only the commands in the command table. If
any other command (a free character string) is
entered, the internal operation mode may become an
improper state.
4. Select "Save" using , ,
remote commander and press the PUSH ENTER
button.
A Setup menu is then displayed.
5. When a LAN interface is set (including the case where
the setting is returned to the initial value), restart the
system using the power switch of the communication
terminal.
2-16
and
and buttons on the
and buttons on the
To stop setting
Select "Cancel" using , ,
commander and press the PUSH ENTER button, or press
the RETURN button on the remote commander.
Service menu function list
Command:
The commands listed in the table below are those for
changing the internal operation mode of the communica-
tion terminal when the system is used in a special environ-
ment.
Command Description
SMS Validates an SMS function.
KV66 For KV-29FX66E monitors.
Sets the input selection to 3 after power on
when a KV-29FX66E monitor is being used.
An IR output is changed so that the command
during power-off sequence is sent properly.
The monitor mode setting is invalidated when
this command is specified, but the mode
setting becomes valid by deleting this com-
mand.
WBxxxXyyy Adjusts the angle of view of the whiteboard
used.
D2B Sets ISDN (2B) to the default value using the
dial menu.
BMR0 AVAYA Bonding Mode Revision 0
PROJ Sends the remote control code for the
projector.
POFF Does not display the packet loss indicator.
E1PRI Changes forcibly to E1
(Default is T1 in NTSC models)
T1PRI Changes forcibly to T1
(Default is E1 in PAL models)
PDx Performs parallel dialing in units of xB (0-29)
(default: in units of 5B).
When 0 is entered, sets the default value 5B.
When 30 or more is entered, sets the default
value 29B.
(Examples: PD1, PD29)
Save Phone Book:
All contents of a phone book are recorded and saved in a
Memory Stick. After execution, a file is created in the area
below in the Memory Stick.
\MSSONY\PRO\TVCONF\LIST\PCS_DLST.CSV
This file can be edited using Microsoft Excel, but do not
change the file name.
and buttons on the remote
PCS-G70/G70P