Table of Contents
Advertisement
S
T
YSTEM
HERMAL
The board supports a 3-pin (1x3-pin) header that allows the
connection of a thermal sensor cable for detecting the system's
internal air temperature. The temperature reading can be seen in
the BIOS Setup Utility.
Pin
Signal
1
D2+_SYS
2
D2+_SYS
3
D2-_GND
S
YSTEM FAN
The SYS_FAN runs on +12V and maintain system cooling. When
connecting the wire to the SYS FAN connector, always be aware
that the red wire (positive wire) should be connected to the +12V.
The black wire (ground wire) and should always be connected to
GND.
Pin
Signal
1
NC
2
+12V-
3
GND
S
ENSOR PIN HEADER
29
Advertisement
Table of Contents
