Connecting The Handset - Cisco SPA 504g User Manual

Numbered objects in
# Description
1 Auxiliary port. (For use only with the Cisco Attendant Console.)
2 Upper slots.
3 Lower slots.
4 PC port.
5 Network (switch) port.
6 Cable run.
7 Handset port.
8 Power port. (Use only with a Cisco PA100 power adapter.)

Connecting the Handset

STEP 1 Turn the phone body over to expose the ports on the back of the device.
CAUTION Do not insert a telephone line cord into the auxiliary (AUX) port.
STEP 2 Insert the long end of the phone cord into the handset port on the phone body that is
marked with a phone symbol.
STEP 3 (Optional) Route the phone cord through the cable slot.
STEP 4 Insert the other end of the phone cord into the port at the bottom of the handset (not
shown).
Figure 1 are described in the following table.
19