buttons and press the Resume softkey. (Not applicable to the Cisco SPA502G or Cisco SPA512G.)
Placing a Call
To place a call, pick up the receiver or press Speaker or Headset and dial the number. It might be
necessary to dial a prefix number or numbers to reach an outside line. (Ask your phone administrator.)
You can also redial a number or select a number from the call history. It might be necessary to modify a
number selected from a call history list so that the phone will dial it correctly.
Redialing a Call
To redial the last number on a Cisco SPA501G, press the Redial button.
To redial another number from a history list on all phones except the Cisco SPA501G:
STEP 1
Press the redial softkey and select the desired number from the Redial list. Or press the
Setup button, select Call History, select the desired call history list, and highlight the desired
number. It might be necessary to modify the number to add a prefix or area code. Press edit
and use the
Softkey Buttons
STEP 2
Lift the handset or press dial to dial the selected number.
Putting a Call on Hold
To put an active call on hold, press the Hold button or the Hold softkey. A series of beeps (default or
optional) or music on hold plays for the caller to indicate that the call is on hold.
Resuming a Call
To resume the call that has been put on hold, press the flashing red line button for the call or the Hold
button or the Resume softkey (if the default behavior is configured.)
to modify a number. When you are finished, press ok.
29