Alcatel-Lucent 7705 SAR-8 System Management Manual page 271

An event filter policy defines (limits) the events that are forwarded to the destination configured in
the log-id. The event filter policy can also be used to select the alarms and traps to be forwarded to a
destination snmp-trap-group.
The application of filters for debug messages is limited to application and subject only.
Accounting records cannot be filtered using the filter command.
Only one filter-id can be configured per log destination.
The no form of the command removes the specified event filter from the log-id.
Default no filter
Parameters
filter-id — the event filter policy ID is used to associate the filter with the log-id configuration. The
from
Syntax from {[main] [security] [change] [debug-trace]}
no from
Context config>log>log-id log-id
Description This command selects the source stream to be sent to a log destination.
One or more source streams must be specified. The source of the data stream must be identified using
the from command before you can configure the destination using the to command. The from
command can identify multiple source streams in a single statement (for example: from main change
debug-trace).
Only one from command may be entered for a single log-id. If multiple from commands are entered,
then the last command entered overwrites the previous command.
The no form of the command removes all previously configured source streams.
Default no from
Parameters main — instructs all events in the main event stream to be sent to the destination defined in the to
7705 SAR OS System Management Guide
event filter policy ID must already be defined in config>log>filter filter-id.
Values 1 to 1000
command for this destination log-id. The main event stream contains the events that are not
explicitly directed to any other event stream. To limit the events forwarded to the destination,
configure filters using the
filter
(log destination) command.
Event and Accounting Logs
Page 271