idronaut Ocean Seven 304Plus Operator's Manual page 50

SECTION FIVE - ITERM – WINDOWS TERMINAL EMULATION PROGRAMME
Port->Set parameters
This function allows the operator to set and define the communication port parameters. Default values
for the OCEAN SEVEN 304Plus CTD are: 38k4bps, 8bit data, 1stop bit, No parity, hardware hand-
checking (CTS/RTS, DTR/DSR) and software hand-checking (XON/XOFF).
Port-
>Close
It closes the open communication port.
Probe->Identify
It identifies the connected CTD; information like the serial number, the hardware and firmware
release are shown on screen.
Probe->Upgrade
This function is not available on the OCEAN SEVEN 304Plus CTD.
Probe->Set Time
It sets up CTD time and date. It is possible to select the time among GMT and local time or to
customize the date and time.
Probe->UploadCast
This function allows the operator to retrieve data stored in the CTD memory storing it in "Text" files
on the PC. The cast uploading is automatically performed by the program. This function is available
only after the CTD has been identified using the Probe Identify function.
IDRONAUT – Brugherio (MB)
OCEAN SEVEN 304Plus CTD
42
12-2015