Show Stored Data; Delete Cast; Initialize Memory; Service Menu - idronaut Ocean Seven 304Plus Operator's Manual

SECTION THREE – COMMANDS

3.4.3. Show stored data

It allows the operator to see the contents of a single cast. Data is sent to the ITERM screen, data set by
data set converted into engineering units. Data showing can be interrupted by means of the <CTRL-
C> character. Here is an example of the message shown on screen once this command is invoked:
Id DataSet 1stSector N.Sectors Acq.Mode Acq.Step Status Time
001 00000003 00000000-00000001 LINEAR 1.00 002 10:19:15 10-09-2012
Cast to show:0 < 1
From the shown list of casts/headers, it is possible to select the cast to show on the screen.
Press Temp Cond Sal
0.01 20.378 0.007
0.01 20.378 0.007
0.01 20.378 0.007

3.4.4. Delete Cast

A single cast can be "marked" as deleted using this command. Deleted cast will not be uploaded from
the PC using the IDRONAUT REDAS-5 and ITERM software.
The cast header and the associated data is not effectively deleted. A deleted cast can be undeleted, if
needed, using the same command. Once invoked, the list of stored cast is shown on the ITERM screen.
Id DataSet 1stSector N.Sectors Acq.Mode Acq.Step Status Time
001 00000003 00000000-00000001 LINEAR 1.00 002 10:19:15 10-09-2012
Cast to delete/undelete 0 < 1

3.4.5. Initialize Memory

This command allows the operator to initialize and effectively delete the CTD memory: data and
headers. This command cannot be reversed: the data is permanently deleted.
Initialize&Delete Memory
Confirm memory initialization ? (1)Yes, (0)No:0 < 1
If the operator answers "1" for YES, the data memory is permanently deleted !
Probe memory has been initialized
Type <any key>To continue
3.5.

SERVICE MENU

CTD diagnostics and configuration functions are available under the Service Menu. Most of the
service functions are password-protected and can be accessed only under the SERVICE or
ADMINISTRATIVE rights. Once invoked, the following message appears on the ITERM screen:
OCEAN SEVEN 304Plus - ID:304-0000000 {USR}[9.0_00-08/2012] 12:58:10.45 11-09-2012
Service
[0]MainMenu
[1]Setup
[2]RealTimeClock
[3]RawCounts
[4]RawmV
[5]Rights
[6]Firmware
[7]Diagnostic
cmd>
IDRONAUT – Brugherio (MB)
0.012 10:20:01.30 10-09-2012
0.012 10:20:03.20 10-09-2012
0.012 10:20:15.10 10-09-2012
OCEAN SEVEN 304Plus CTD
25
12-2015