Toolbar; Start-Up Switches; Troubleshooting; Tools - idronaut Ocean Seven 304Plus Operator's Manual

SECTION FIVE - ITERM – WINDOWS TERMINAL EMULATION PROGRAMME
5.4.

TOOLBAR

On the programme toolbar, there are the shortcuts to the programme functions.
Disconnects the communication port, freeing the port for other programmes or allowing the
communication port parameter modifications.
Detects and identifies the connected OCEAN SEVEN CTD type. At the end of the identification
on the status and title bar of the programme, the information about the connected CTD
appears.
Upgrades the connected and identified CTD firmware.
Sets the connected CTD time and date, according to the PC or custom settings.
Accesses the communication port parameter set-up.
Captures transmissions from the connected CTD and keyboard typing and stores them in the
selected text file. A red cross appears over the icon when running. Pressing once stops the
capture and closes the text file.
5.5.

START-UP SWITCHES

It is possible to customize the programme at the start-up by adding the following switches to the
programme properties:
- p x Where x represents the communication port number 1..8.
- b bps Where bps represents the communication speed and can be 1200, 2400, 4800, 9600, 19200,
38400, 57600, 115200.
5.6.

TROUBLESHOOTING

The automatically generated files "Detect.log" and "Upgrade.Log" contain the dialog between the
programme and the CTD concerning the operations of CTD detection and CTD upgrading. In case of
trouble, please send us the above files together with a short description of the problem.

5.6.1. Tools

Together with ITERM, IDRONAUT distributes the following utility programs under the "tools"
folder of ITERM:
Swpc
UnitConvert
Interpolate
OceanSevenCalibration Acquire and store data for CTD re-calibration.
IDRONAUT – Brugherio (MB)
Sea water properties calculator.
Convert among different units.
Linear/Logarithmic interpolation calculator.
OCEAN SEVEN 304Plus CTD
44
12-2015