idronaut Ocean Seven 304Plus Operator's Manual page 37

SECTION THREE – COMMANDS
Windows Personal Computer Preparation
The firmware is shipped together with the ITERM (IDRONAUT Terminal Emulation Programme).
The installation of ITERM is simple and does not require running any set-up.
Proceed as follows:
 Copy the OS304Plus firmware upgrading package to a dedicated folder on the computer hard disk.
 Unpack it using WINZIP or any other file uncompressing utility.
 From the desktop and using the Windows resources, create a link on the desktop pointing to the
ITERM programme.
 Run the ITERM programme. It starts with the correct communication parameters already set.
 You are ready to switch ON the OS304Plus device.
Note
 The ITERM port configuration is the following:





 The ITERM programme help contains the description of the programme main functions.
OS304Plus preparation
Connect the laboratory cable between the personal computer communication port and the OS304Plus
and then switch on the OS304Plus. As soon as you switch the OS304Plus on, the start-up messages
must appear on the ITERM window.
Once the OS304Plus main menu appears, select the Service Menu and then select command 5. This
command allows the operator to access the "SETUP" using administrative rights. Once the command
is sent, the following message appears:
Access rights<<
Answer the request by typing "ROOTACCESS". If the password is correctly entered and accepted,
the menu appears again. From the shown service menu, select command 1 SETUP! Go through the
parameters using the ENTER key until the request about the MAIN com port speed appears.
OCEAN SEVEN 304Plus - Setup
Configuration[191]-Status[177]-Calibration[309]{F8E5}
Warm-up timeout [s]:0 <
Number of rows between headers [1..255]:22 <
Main com. port BPS: 0)9k6,1)19k2,2)38k4,3)57k6,4)115k2:0 <
IDRONAUT – Brugherio (MB)
Communication speed
Data bit
Stop bit
Parity
Flow Control
OCEAN SEVEN 304Plus CTD
38400 bps
8
1
None
None
29
12-2015