Safety Information; Understanding Safety-Alert Messages; Following Safety Instructions; Replacement Instructions And Labels - S&C BankGuard PLUS Troubleshooting Instructions

Hide thumbs Also See for BankGuard PLUS:

Setup instructions (50 pages)

Operation instructions manual (28 pages)

Installation manual (24 pages)

Table of Contents

Understanding

Safety-Alert

Messages

Following Safety

Instructions

Replacement

Instructions and

Labels

There are several types of safety-alert messages which may appear throughout this

instruction sheet as well as on labels attached to the IntelliTEAM II Interface Module.

Familiarize yourself with these types of messages and the importance of the various

signal words, as explained below.

"DANGER" identifies the most serious and immediate hazards which will likely re-

sult in serious personal injury or death if instructions, including recommended pre-

cautions, are not followed.

"WARNING" identifies hazards or unsafe practices which can result in serious per-

sonal injury or death if instructions, including recommended precautions, are not fol-

lowed.

"CAUTION" identifies hazards or unsafe practices which can result in minor personal

injury or product or property damage if instructions, including recommended precau-

tions, are not followed.

"NOTICE" identifies important procedures or requirements that, if not followed, can

result in product or property damage if instructions are not followed.

If you do not understand any portion of this instruction sheet and need assistance, con-

tact your nearest S&C Sales Office or call S&C Headquarters at (773) 338-1000, Monday

through Friday between 8:30 AM and 5:00 PM Central Standard Time. (In Canada, call

S&C Electric Canada Ltd. at (416) 249-9171.)

Thoroughly and carefully read this in-

struction sheet before programming

and operating your IntelliTEAM II In-

terface Module.

If you need additional copies of this instruction sheet, contact your nearest S&C Sales

Office, S&C Headquarters, or S&C Electric Canada Ltd.

It is important that any missing, damaged, or faded labels on the equipment be replaced

immediately. Replacement labels are available by contacting your nearest S&C Sales

Office, S&C Headquarters, or S&C Electric Canada Ltd.