Lexmark T650n Service Manual page 415

4. Pull the media bin latch from its boss to remove.
Output expander media output bin assembly removal
1. Remove the left and right output expander media bin latches. See
and right) removal" on page
2. Remove the standard output bin LED. See
page 4-138.
3. Rotate the output bin assembly downward and out of the slots to remove.
Output expander media bin full actuator removal
1. Remove the output expander left inner cover. See
page 4-136.
2. Unsnap the actuator from its hinges and pull out to remove.
Output expander sensors (media bin full) assembly removal
1. Remove the output bin left inner cover. See
2. Untwist the sensor harnesses from the cable guide.
3. Depress the tabs securing the sensors (media bin full) and remove.
Replacement Note: Be sure to replace the sensors in the correct order. Make sure their positions are not
switched.
4. Remove the output expander controller card cover panel. See
panel removal" on page
5. Disconnect the sensor (media bin full) harness from the controller card and remove.
Output expander sensor (media bin full) bracket assembly removal
1. Remove the output expander left inner cover. See
page 4-136.
2. Grasp the sensor bracket and pull away from the option while depressing the tab.
3. If replacing the bracket, remove the sensors (media bin full) from the bracket.
Replacement Note: Be sure to replace the sensors in the correct order. Make sure their positions are not
switched.
Output expander controller card cover panel removal
1. Remove the output expander media output bin assembly. See
assembly removal" on page
2. Remove the screw (A) on the back side of the option.
3. Remove the grounding screw (B) on the right output option frame guide the grounding cable through the
hole in the frame.
4. Carefully flex the panel from the lower middle and pull the four tab (C) out of the frame and remove.
Output expander controller card removal
1. Remove the output expander controller card cover panel. See
panel removal" on page
2. Disconnect all harnesses from the controller card.
3. Remove the two screws (A) securing the controller card to the frame.
4-136.
"Output expander standard output bin LED removal" on
"Output expander left inner cover removal" on
"Output expander left inner cover removal" on page
4-137.
"Output expander left inner cover removal" on
4-137.
4-137.
"Output expander media bin latch (left
"Output expander controller card cover
"Output expander media output bin
"Output expander controller card cover
Repair information
4062-XXX
4-136.
4-137