Lexmark T650n Service Manual page 414

4062-XXX
4. Remove the four screws (B) securing the left frame assembly to the 5-bin mailbox assembly.
5. Move the left frame assembly out of the way.
6. Remove the 5-bin mailbox sensor (diverter gate HP) by pressing the tabs.
7. Disconnect the harness from the 5-bin mailbox sensor (diverter gate HP).
5-bin mailbox output bin LED assembly removal
1. Remove the 5-bin mailbox right outer cover.
2. Disconnect the two harness to the 5-bin mailbox output bin LED assembly.
3. Remove the two screws (A) securing the 5-bin mailbox output bin LED assembly to the right frame.
4. Remove the 5-bin mailbox output bin LED assembly.
Output expander rear door assembly removal
1. Open the rear door assembly.
2. Hold the door to approximately 45° angle, and force out the left hinge and slide the right hinge out to remove
the door.
Output expander left outer cover removal
1. Remove the output expander rear door assembly. See
on page 4-136.
2. Grasp the lower rear corner of the left outer cover and pull out to remove.
Output expander left inner cover removal
1. Remove the output expander left outer cover. See
page 4-136.
2. Remove the screw (A) securing the left inner cover.
3. Holding the rear of the left inner cover, pull out while simultaneously separating it from the option.
Output expander right outer cover removal
1. Remove the output expander rear door assembly. See
on page 4-136.
2. Grasp the lower rear corner of the right outer cover and pull out to remove.
Output expander right inner cover removal
1. Remove the output expander right outer cover. See
page 4-136.
2. Remove the screw (A) securing the right inner cover to the unit.
3. At the rear of the right inner cover, pull out from the option and remove the right inner cover.
Output expander media bin latch (left and right) removal
1. Remove the output expander left or right inner cover. See
on page 4-136
2. If removing the right side media bin latch, use a springhook to pull the media bin latch spring off the spring
post on the output expander frame.
3. If removing the left side media bin latch, just pull out on the bottom of the latch and pull the top off the boss.
4-136
Service Manual
or "Output expander right inner cover removal" on page
"5-bin mailbox right outer cover removal" on page
"Output expander rear door assembly removal"
"Output expander left outer cover removal" on
"Output expander rear door assembly removal"
"Output expander right outer cover removal" on
"Output expander left inner cover removal"
4-133.
4-136.