Step
4
Check the above sensor for proper connection.
Is the above sensor connected properly?
5
Perform a print test using the output option.
Does the error continue?
Sensor (output pass through) static jam service check
Step
1
Check the media path for partially fed or jammed media.
Is the media path free from partially fed or jammed media?
2
Check the sensor (output pass through) for proper
operation.
1. Enter the diagnostic mode
2. Select Output bin tests
3. Select Sensor test
4. Select Output bin x
5. Observe the line item "passthru"
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked.
Check
Check
Yes
Replace the
Replace the
sensor (output
connection.
pass through).
Go to
"High
capacity stacker
sensor (pass
through)
removal" on
page
4-132.
Go to
"5-bin
mailbox sensor
(pass through)
removal" on
page
4-134.
Go to
"Output
expander sensor
(pass through)
removal" on
page
4-138.
Replace the output
Problem solved.
option.
Yes
Go to step 2.
Remove any pre-
staged or jammed
media.
Go to step 4.
Go to step 3.
Diagnostic information
4062
No
No
2-143