Lexmark T650n Service Manual page 413

2. Using a springhook, remove the diverter spring from the diverter.
3. Unsnap each side of the diverter and remove.
Replacement Note: The static brush mylar assembly is attached to the media bin fifth diverter. Do not forget
to reinstall it on the new diverter.
5-bin mailbox upper diverter spring removal
1. Remove the 5-bin left inner cover. See
2. Remove the following harnesses from the controller card: J14 A and B, J2, and J11.
3. Remove the two screws (A) securing the controller card assembly and move the card to the side.
4. Remove the four screws (B) securing the left frame assembly to the 5-bin mailbox assembly.
5. Move the left frame assembly out of the way.
6. Remove the upper diverter spring.
5-bin mailbox media bin extension assembly removal
1. Fully extend the media bin extension.
2. Depress the two tabs on the underside of the extension and pull out the rest of the way.
5-bin mailbox output bin LED bracket removal
1. Remove the screw (A) securing the output bin LED bracket to the underside of output bin one.
2. Remove the 5-bin mailbox output bin LED bracket
3. Disconnect the output bin LED harness from the LED.
4. The output bin bracket, output bin LED, and LED clear lens are free to be removed.
5-bin mailbox diverter gate solenoid removal
1. Remove the 5-bin mailbox right outer cover. See
page 4-133.
2. Remove the 5-bin mailbox left outer cover. See
3. Remove the top cable cover panel.
4. Remove the screw (A) securing the appropriate 5-bin mailbox diverter gate solenoid.
5. Remove and unroute the cable to the diverter gate solenoid.
6. Disconnect the proper diverter gate solenoid harness from the controller card.
Note: To ease the cable unrouting, cut the appropriate cable.
5-bin mailbox transport solenoid removal
1. Remove the 5-bin mailbox left outer cover. See
2. Disconnect J15 at the controller card.
3. Remove the screw (A) securing the 5-bin mailbox transport solenoid to the left frame.
4. Remove the 5-bin mailbox transport solenoid.
5-bin mailbox sensor (diverter gate HP) removal
1. Remove the 5-bin left inner cover. See
2. Remove the following harnesses from the controller card: J14 A and B, J2, and J11.
3. Remove the two screws (A) securing the controller card assembly and move the card to the side.
"5-bin mailbox left inner cover removal" on page
"5-bin mailbox right outer cover removal" on
"5-bin mailbox left outer cover removal" on page
"5-bin mailbox left outer cover removal" on page
"5-bin mailbox left inner cover removal" on page
4062-XXX
4-133.
4-133.
4-133.
4-133.
4-135
Repair information