Lexmark T650n Service Manual page 306

4062-XXX
5. Remove the MPF pick solenoid assembly. See
T654)" on page
6. Remove the two screws (B) securing the alignment assembly to the machine.
Note: The adjuster screw (C) requires a hex wrench to loosen and tighten.
Note: The adjuster screw (C) can be accessed through the hole (D) in the system card.
7. Completely loosen the adjuster screw (C) securing the alignment assembly to the machine.
8. Remove the alignment assembly.
Replacement Warning: When replacing the alignment assembly, ensure that the media skew is properly
adjusted using the adjuster screw (C) or jamming will occur. See
page 4-4.
4-28
Service Manual
4-33.
D C
"MPF pick solenoid assembly removal (T650, T652,
B
"Alignment assembly adjustment" on