Projector Management Using Snmp - Christie APS Series User Manual

8. Other Functions

8.2 Projector Management using SNMP

The SNMP (Simple Network Management Protocol) enables to manage the
projector information, which is a failure or warning status, from the computer on
the network.
NOTE
• It is recommended that SNMP functions are executed by a network
administrator.
• SNMP management software must be installed on the computer to monitor
the projector via SNMP.
Standard MIB (MIB-2)
You can refer to the following items defined in system group of Standard MIB
(MIB-2).
Item
sysName
sysLocation
sysContact
Enhanced MIB
You can get configuration information by using Enhanced MIB for projectors.
Enhanced MIB for projectors can be downloaded from [Port Settings] page in
Projector Web Control.
Trap
When an error or warning occurs in the projector, a notification can be sent to the
specified address.
In addition to email alert shown in 8.1 Email Alerts (&89), the following notification
can be sent.
Item
Cold Start
Authentication Failure
LWU650-APS/LWU530-APS
User's Manual - Network Guide
Projector name is set.
The information on where it is located. It has character string
set in sysLocation (SNMP) in Projector Web Control - [Network
Settings] - [Common Setup].
The information on the administrator's contact information. It
has character string set in sysContact (SNMP) in Projector
Web Control - [Network Settings] - [Common Setup].
When the projector is supplied with the power, it works as
below.
• If the STANDBY MODE is set to the QUICK START or
NORMAL: the projector's power status changes from "OFF" to
"Standby state".
• If the STANDBY MODE is set to the NETWORK-WOL or
POWER SAVE: the projector's power status changes from
"Standby state" to "ON (light source is turned on)".
&
( SETUP menu in the Operating Guide).
The SNMP access is detected from the invalid SNMP
community.
92
Description
Description
020-001538-01 Rev. 1 (11-2018)
LIT GUID SET APS Series NET