Maintenance And Care; Disassembly And Assembly Of The Clamping Block - SCHUNK TANDEM KSF plus Series Assembly And Operating Manual

9

Maintenance and care

To ensure fault-free operation of the clamping block, the following
instructions must be observed:
• Make sure the bore hole for coolant drainage remains
unblocked!
• Depending on the load, but at least once a month or after every
10,000 clampings, grease the guides on the two frontal or the
two lateral lubricatiion nipples with LINOMAX 200 or an
equivalent lubricant. The chuck jaws must be in the open
position during lubrication.
• Disassemble the base jaw and chuck piston at least once every
three months (or more often, if necessary). Clean the housing,
base jaw and chuck piston and lubricate all the guides (housing,
base jaw, chuck piston) with LINOMAX 200 or an equivalent
lubricant. Reassemble everything and relubricate the two
frontal or the two lateral lubricating nipples with LINOMAX 200
or an equivalent lubricant.
(Product information about LINOMAX can be requested from
SCHUNK).
CAUTION
Skin contact with lubricating grease can cause allergic reactions!
Wear protective gloves.
9.1

Disassembly and assembly of the clamping block

The item numbers specified for the corresponding individual
components relate to chapter
WARNING
Danger of injury during disassembly of clamping block because
of the high spring pressure in the cover.
• Only specialist personnel may disassemble the clamping block!
• The cover may only be removed with the aid of a suitable
disassembly device!
Maintenance and care
drawings.( 11, Page 43)
03.00|KSF plus, KSF-LH plus, KSF-F plus |en
23