Screen Innovations Nano Roll 275 Series Installation Instructions Manual page 6

INSTALLATION - 24 VDC - SDN (375 / 475 SERIES)
1. Terminate pre-wire with terminal block
+ 24 VDC
V+
- 24 VDC
V-
Data + +
Data - -
G
Data ground
2. If mounting to a wall, remove the ceiling flange from motor and idler brackets
Installation - Nano Roll - 24VDC - SDN (375 / 475)
Header
Data For SDN Only
Pg 9
INSTALLATION - 24 VDC - SDN (375 / 475 SERIES)
3. Install wall bracket/end cap assembly with the supplied screws
for Ceiling Mount
for Wall
Mount
Motor
side
4. Measure bracket to bracket width and verify it matches the ordered width. Adjust accordingly.
Installation - Nano Roll - 24VDC - SDN (375 / 475)
Idler
side
Use 5/16" magnetic
driver (incl.)
Brackets must be level before the
shade is installed!
Pg 10