Summary of Contents for Screen Innovations Zen Roll
Page 1
Zen Roll Owner’s Manual Screen Innovations 9715-B Burnet Rd, Suite 400 Austin, TX 78758 512.832.6939 with ShyZip Tracks ® www.screeninnovations.com INSTALLERS: PLEASE LEAVE THIS MANUAL WITH THE OWNER. v. 1.2 15 October 2019...
Innovations’ option) the defective part of the merchandise. Returns for service should be made to your Screen Innovations' dealer. If it is necessary for the dealer to return the screen or part to Screen Set Limits (Motorized only) ............. 18 - 20 Innovations, transportation expenses to and from Screen Innovations are payable by the purchaser and Screen Innovations is not responsible for damage in shipment.
OPERATING AND MAINTAINING YOUR SHADE BEFORE PROCEEDING • Operation of the shade systems should only be completed by qualified person(s) Read the instructions in their entirety before proceeding. Actions contrary to the instructions invalidate the warranty and may result in serious damage and/or injury. •...
SPECIFYING YOUR SHADE DIMENSIONS SPECIFYING YOUR SHADE DIMENSIONS Between Columns Ceiling Mount Wall Surface Mount Use these formulas for specifying shades were the case and guide tracks can be seen from the inside Use these formulas for specifying shades where the case and guide tracks can NOT be seen from of the installation opening.
PARTS IN THE BOX INSTALL BRACKETS Mount the motor and idler brackets to structural supports as shown. Refer to your order or Shades the packaging to get the UNIT WIDTH = W and make sure the brackets measure the same UNIT WIDTH dimension from outside to outside.
INSTALLING MATERIAL ROLL INSTALLING MATERIAL ROLL Lift the idler end with bushing already installed up into the idler housing. Then secure with the screw Installation requires two or more people. Please use safe lifting and removed in step 1. rigging techniques. Remove the screw from the idler side bracket, then remove the idler bushing and install on the material roll idler shaft.
CUTTING TRACK TO LENGTH INSTALLING THE TRACKS - To be installed and/or used in accordance with the appropriate electrical codes and regulations by Measure the distance from the top of the mounting brackets to the floor. Then cut the bottom end a licensed electrical professional.
Page 8
INSTALLING THE TRACKS - INSTALLING THE TRACKS - Align the track with the screen material zipper. Notches for mounting from the front or side have Angle the zipper track up into and behind the upper most spring. The top of the track is the side with been provided to guide fastener installation.
INSTALLING THE TRACKS - POWER (MOTORIZED ONLY) To be installed and/or used in accordance with the appropriate electrical codes and Do not use powered screw driver to avoid stripping screws. regulations by a licensed electrical professional. Do not connect power with the circuit breaker on.
SET LIMITS (MOTORIZED ONLY) Adjusting the limits in User mode Programming mode To change the lower limit To change the upper limit Send the shade to it’s current lower limit. Send the shade to it’s current upper limit. Before you begin Motors are shipped without limit settings and transmitter ID’s.
TROUBLESHOOTING Obstacle Detection - Change the level of Detection or Deactivate Problems related to electrical or motor function may require a qualified service person or electrician. Tech Support: 512.832.6939 When Programming, all button presses must be completed within 2 seconds of the previous press. This function gives the possibility to deactivate the obstacle detection or increase the sensitivity up Problem Probably Cause...