Screen Innovations Nano Roll 275 Series Manual Operation Instructions
Hide thumbs
Also See for Nano Roll 275 Series:
- Installation instructions manual (6 pages) ,
- Installation instructions manual (10 pages) ,
- Installation instructions manual (20 pages)
Related Manuals for Screen Innovations Nano Roll 275 Series
Summary of Contents for Screen Innovations Nano Roll 275 Series
- Page 1 Nano Roll ® Manual Operation Instructions Screen Innovations 9715-B Burnet Rd, Suite 400 Austin, TX 78758 512.832.6939 www.screeninnovations.com INSTALLERS: Please leave this manual with the owner. PART NO. 400033 Version 1.0...
- Page 2 PARTS LIST – Nano Roll – Manual Operation ADDITIONAL ACCESSORIES LIST – Nano Roll – Manual Shade Wall Brackets Spanner Wrench Set Screw Hex Tool 275 Roll End Caps Pre-Tension Tool Screws included (3 per bracket) Note: For more information about these tools and their use, please call Tech Support at 512.832.6939 Opt.
- Page 3 SHADE ORIENTATION - Standard Roll SHADE ORIENTATION - Reverse Roll Before installing the shades, verify whether the shade was ordered as standard roll or reverse roll. The illustrations in this manual show standard roll shades, but the installation procedure for reverse roll shades is very similar.
- Page 4 PRE-TENSION – Nano Roll – Manual Operation PRE-TENSION – Nano Roll – Manual Operation Before installing a Nano manual shade, the spring tension must be set. The amount of pre-tensions 2. Turn the spring control an extra 1/4 turn and slowly release it to lock the shade spring in place. required for each shade varies and can be found on the attached shade list.
- Page 5 INSTALLATION – Nano Roll – Manual Operation INSTALLATION – Nano Roll – Manual Operation NOTE: Nano manual shade brackets are intended to be wall mounted. They may be ceiling mounted, but the appearance is degraded. 4. Insert the idler side, making sure the four small pins are engaged with the bracket. 1.
- Page 6 VERIFY – Spring Tension and Upper Limit VERIFY – Spring Tension and Upper Limit 3. If the shade moves too slowly, remove from bracket and add one pre-tension turn at a time 1. Pull the shade down approximately halfway. until the desired speed is achieved. 4.
-
Page 7: Troubleshooting
VERIFY – Spring Tension and Upper Limit TROUBLESHOOTING Tech Support: 512.832.6939 Problem Cause Solution 5. Adjust the shade limiter using the included spanner wrench as shown below. Shade is slow or jerky Spring does not have Add one pretension turn at a time until the shade when moving up enough pre-tension turns operates smoothly.