Screen Innovations Nano Roll 275 Series Installation Instructions Manual page 4

INSTALLATION - 24 VDC - SDN (275 SERIES)
Before installing the shades, verify whether the shade was ordered as standard roll or reverse roll. Though
illustrations in this manual show standard roll shades, the installation for reverse roll shades is the same.
1. Terminate pre-wire with terminal block
+ 24 VDC
V+
- 24 VDC
V-
Data +
+
-
Data -
Data ground G
2. Install wall bracket/end cap assembly with the supplied screws
for Ceiling Mount
for Wall Mount
Motor
side
Installation - Nano Roll - 24VDC - SDN (275)
Header
Data For SDN Only
Idler
side
Use 1/4" magnetic
driver (incl.)
INSTALLATION - 24 VDC - SDN (275 SERIES)
3. Measure bracket to bracket width and verify it matches the ordered width. Adjust accordingly.
4. Remove idler end cap with flat screw driver
Pg 5 Installation - Nano Roll - 24VDC - SDN (275)
Brackets must be level before the
shade is installed!
Pg 6