Notice!
The display offers only limited configuration options. The configurable parameters are
described here in chapter 7.3.
Only the webConfig provides complete configuration options and is largely self-explanatory.
The use of the webConfig tool is described in chapter 6. There, you will also find notes on
commissioning with the aid of webConfig.
7.3.2
Status displays
IO1 IO2 IO3 IO4
IO5 IO6 IO7 IO8
ATT ERR TMP
Status
Network settings
Sw. inputs/outputs
Network settings
Channel 1:
Addr:
Mask:
Gateway: 0.0.0.0
ESC
# Name
1 Start trigger
2 Result OK
3 Result NOK
4 Programmable 1
5 Programmable 2
7.3.3
Statistics
Statistics
Counter state
Tested:
OK:
NOK:
Leuze electronic
RS232
ETH 100
OK
192.168.60.101
255.255.255.0
Status
I
O
O
O
O
0
0
0
Status displays - main menu
• Status displays of the switching inputs/outputs
• Display of warnings and errors
• Status information for the device interfaces
• Optional: check program-specific display
See "Indicators in the display" on page 41.
Press the enter button to select between network settings and switching
inputs and outputs.
The Network settings submenu offers information on the set network
address of the LSIS 4xxi, the corresponding net mask and the gateway
address.
Value "Channel 1" is displayed by default. Currently (06/2009), only one
Ethernet channel is supported.
The Sw. inputs / outputs submenu offers information on the current
configuration of the IOs of the LSIS 4xxi.
For each of the 8 IOs, the assigned name and state are displayed
(input = I/output = O).
Statistics - main menu
In the Statistics menu, you can see the total number of parts that have
been checked since the last time the counter was reset, how many test
results were OK and how many were not OK.
LSIS
4xxi
Display and control panel
45