7.2.3
LED status displays
PWR LED
off
flashes green
green continuous light Device ok
orange continuous light Service mode
flashes red
red continuous light Device error / parameter enable
BUS LED
off
flashes green
green continuous light BUS ok
flashes red
Leuze electronic
Device OFF
- no supply voltage
Device ok, initialization phase
- no inspection possible
- voltage connected
- self test running
- initialization running
- check program is activated
- inspection mode
- self test successfully finished
- device monitoring active
- configuration mode
- configuration via webConfig
Device ok, warning set
- inspection mode
- temporary operating fault
- for details, see "Error signaling via LED" on page 51
- no inspection possible
- for details, see "Error signaling via LED" on page 51
No supply voltage
- no communication possible
Bus initialization
- can be very short, 1 pulse
- device ready for sending/receiving
Communication error
- UART error (frame error, parity error, ...)
LSIS
4xxi
Display and control panel
43