Integrating The Lsis 4Xx; Figure 6.1: Connecting The Lsis 4Xx I To The Pc - Leuze electronic LSIS 4xxi Series Original Operating Instructions

Figure 6.1:
The PC first tries to establish a network connection via the automatic configuration. This
takes a few seconds, after which the alternate configuration, which you just set, is activated.
The PC can then communicate with the LSIS 4xxi.
6.1.4 Integrating the LSIS
If it should be possible to reconfigure the LSIS
network connection is present at the installation site, you can set the LSIS
the parameters of the existing network. In principle, it is possible in this case to have the
address set automatically by means of DHCP, or you can assign a fixed address.
 Ask your network administrator which method is to be used and — if using fixed address
assignment — which settings should be used for address, subnet mask and gateway.
With DHCP server
 Use the display on the LSIS to activate the DHCP function (see "Changing the network
settings on the display" on page 49).
Following activation of the DHCP function, the sensor automatically restarts. If you now
connect the sensor to a network with DHCP server, it is automatically assigned an IP
address.
You can now configure the LSIS
With fixed IP address
 Use the display on the LSIS to set the parameters previously received by the network
administrator (see "Changing the network settings on the display" on page 49).
The sensor restarts after the Ethernet configuration is changed. If you now connect the
sensor to a network, it operates with the manually assigned IP address.
You can now configure the LSIS
Leuze electronic
Connecting the LSIS
4xxi in an existing network
4xxi
4xxi
Commissioning and configuration
4xxi to the PC
4xxi later during running operation and if a
via any PC on the same network.
via any PC on the same network.
LSIS 4xxi
4xxi according to
38