Configuring Via Webconfig; Figure 6.2: Webconfig Start Page - Leuze electronic LSIS 4xxi Series Original Operating Instructions

6.2

Configuring via webConfig

With Leuze webConfig, an operating-system independent, web-technology based, graph-
ical user interface is available for configuring smart cameras of the LSIS
Through the use of HTTP as communication protocol and by using only standard technolo-
gies on the client side (HTML, JavaScript and AJAX), which are supported by all commonly
used, modern browsers (e.g. Mozilla Firefox beginning with Version 3.0 or Internet
Explorer beginning with Version 8.0), it is possible to operate the Leuze webConfig tool
on any internet-ready PC.
Start a browser on your PC and enter the following address: 192.168.60.101 or the address
previously set by you / the address assigned by the DHCP server.
192.168.60.101 is the default Leuze service address for communication with the
smart cameras of the LSIS
You can check the network address of the LSIS
display three times in sequence during normal operation of the LSIS 4xxi.
If the IP address is entered correctly in the browser, the following start page appears on your
PC.
Figure 6.2:
Notice!
The webConfig tool is completely contained in the firmware of the LSIS 4xxi. Depending on
firmware version, the start page may vary from that shown above.
Leuze electronic
4xxi series.
webConfig start page
Commissioning and configuration
4xxi by pressing the enter button
LSIS 4xxi
4xxi series.
on the
39