Programming Flash On The Board Using Dediprog - Intel Quark SoC X1000 User Manual

11 Programming flash on the
board using DediProg
You can use a DediProg* SF100 SPI Flash Programmer and the associated flashing
software to program your board.
Note: These steps require the Flash+PlatformData.bin file that was created in
Once the software has been installed and the programmer is connected to the board,
open a new terminal session, and run the DediProg Engineering application.
Use the following steps to flash the board:
1. Select the memory type if prompted when the application starts.
2. Select the File icon and choose the *.bin file you wish to flash.
3. Optionally select the Erase button to erase the contents of the SPI flash.
4. Select raw file format.
5. Select the Prog icon to flash the image onto the board.
6. Optionally select the Verify icon to verify that the image flashed correctly.
Note: Intel recommends that you disconnect the programmer before booting the system.
Intel ® Quark™ SoC X1000
BSP Build and Software User Guide
28

Programming flash on the board using DediProg

Order Number: 329687-007US
Section 9.