Creating A File System And Building The Kernel Using Yocto [Linux Build Environment Only] - Intel Quark SoC X1000 User Manual

Creating a file system and building the kernel using Yocto [Linux build environment only]

6 Creating a file system and
building the kernel using Yocto
[Linux build environment only]
Dependencies:






Note: git requires proxy configuration. If these commands fail, it may be due to your proxy
settings. Contact your network administrator. You may find answers about proxy
settings here:
Use Yocto to create a root file system and kernel that boots the system from an SD
card or USB key. Do not run any of the commands in this section as root.
Note: See
To avoid a known issue unzipping packages with long file paths, extract the
meta-clanton tarball into a directory with a short path, for example /tmp.
First, open a new terminal session, extract the Yocto layer, and run the setup.sh
script to download the external sources required for the Yocto build:
# sudo apt-get install diffstat gawk chrpath
# tar -xvf meta-clanton*.tar.gz
# cd meta-clanton*
# ./setup.sh
Note: The setup.sh script takes no parameters. To build the root file system and kernel for
the Intel
Next, source the oe-init-build-env command to initialize the Yocto build
environment, and run bitbake <target> to build the root file system and kernel. You
will use SoC-specific <target> commands described below.
Note: If you need to patch the Linux kernel (optional), skip to
patch before running the bitbake command.
Order Number: 329687-007US
git
diffstat
texinfo
gawk
chrpath
file
https://wiki.yoctoproject.org/wiki/Working_Behind_a_Network_Proxy
Section 7 to build development tools (gcc) for the Linux* operating system.
® Galileo board, see the commands below.
Section 6.1 and apply the
Intel ® Quark™ SoC X1000
BSP Build and Software User Guide
15