Parameters/Address Space; Parameters - Siemens SIMATIC ET 200SP Manual

4.2

Parameters/address space

4.2.1

Parameters

Parameters of the DQ 4×24..230VAC/2A HF
The following table lists the configurable parameters in PC mode.
The effective range of the configurable parameters depends on the type of configuration.
The following configurations are possible:
● Central operation with an ET 200SP CPU
● Distributed operation on PROFINET IO in an ET 200SP system
● Distributed operation with PROFIBUS DP in an ET 200SP system
When performing the configuration in the user program, use the "WRREC" instruction to
transfer the parameters to the module using data records (refer to the section Parameter
assignment and structure of parameter data record (Page 51)).
The following parameter settings are possible:
Table 4- 1 Configurable parameters and their defaults (GSD file)
Parameter
Module parameters
Control type
•
•
•
•
DQ 4x24..230VAC/2A HF digital output module (6ES7132-6FD00-0CU0)
Manual, 02/2018, A5E42404845-AA
Range of values
Phase control -
Phase control -
phase-angle
phase-angle propor-
proportional
tional
Phase control -
power-proportional
Wave packet control
- half waves
Wave packet control
- full waves
Default Reconfiguration
in RUN
Yes
4.2 Parameters/address space
Effective range with configuration
software, e.g. STEP 7 (TIA Portal)
GSD file GSD file
PROFINET IO PROFIBUS DP
Module Module
PC mode
1
31