Parameters / Address Space; Parameters - Siemens SIMATIC S7-1500 Manual

Parameters / address space

4.1

Parameters

Parameters (GSD file)
The following table shows the general parameters for the IO-Link Master CM 8xIO-Link
communication module.
The default settings of the parameters are marked in bold in the "Value ranges" column.
Table 4-1 General parameters (GSD file)
Parameters
Diagnostics
Diagnostics: No supply voltage L+
Diagnostics: Port
Master parameter
Port Qualifier Information (PQI)
Port configuration without S7-PCT
The following table shows the port parameters for the IO-Link Master CM 8xIO-Link
communication module.
Parameters
Port configuration
Operating mode
Length of the input data*
Length of output data
* If PQI is activated, 1 byte less space remains for input data of the device. For example: GSD setting 16
bytes = 15 bytes + PQI
** Make sure not to exceed the maximum possible length of the input or output data for all ports.
*** Only effective if you use the "IO-Link Manual" port mode.
Communication module IO-Link Master CM 8xIO-Link (6ES7547-1JF00-0AB0)
Equipment Manual, 08/2022, A5E45488510-AB
Value range
• Disable
• Enable
• Disable
• Enable
• Disable
• Enable
• Disable
• Enable
Value range
• IO-Link Autostart
• IO-Link Manual
• DI
• Deactivated
depending on the selected
input/output type**
depending on the selected
input/output type**
Effective range
Module
Port (channel)
Module
Module
Default
IO-Link Autostart
depending on the selected
input/output type**
depending on the selected
input/output type**
4
19