Siemens SIMATIC ET 200SP Manual page 34

Parameter
Channel output
•
filter up
•
•
•
•
•
•
Channel substitute 0...1000
value [0.1%]
2
Potential group
Potential group
•
•
Due to the limited number of parameters of a maximum of 244 bytes per ET 200SP station with a PROFIBUS GSD
1
configuration, the parameter assignment options are restricted. The parameter length of the I/O module is 7 bytes with
PROFIBUS GSD configuration. If necessary, you can set this parameter by using the data record 128, see the appendix
"Parameter data set".
For physical reasons, a wire break cannot be detected for actuators with two inputs and shared reference point. In this
2
case, deactivate the diagnostics.
The Overflow and Channel substitute value [0.1%] diagnostics are only available if you configured the module in PC
3
mode.
DQ 4x24..230VAC/2A HF digital output module (6ES7132-6FD00-0CU0)
Manual, 02/2018, A5E42404845-AA
Range of values
No filter
No filter
500 ms
1 s
5 s
10 s
30 s
60 s
0
Use potential
Use potential group
group of the
of the left module
left module
(module plugged in-
to a dark BaseUnit)
Enable new poten-
tial group (module
plugged into light-
colored BaseUnit)
Default Reconfiguration
in RUN
Yes
Yes
No
4.2 Parameters/address space
Effective range with configuration
software, e.g. STEP 7 (TIA Portal)
GSD file GSD file
PROFINET IO PROFIBUS DP
Channel -
Channel Channel
Module Module
PC mode
1
33