Taylor C708 Operator's Manual page 59

PROBLEM
7. The product is too thick.
8. The mix in the hopper is
too warm.
9. The mix in the hopper is
too cold.
10. Mix Low and Mix Out
probes are not
functioning.
11. Product is collecting on
top of the freezer door.
12. Excessive mix leakage
from the bottom of door
spout.
13. Excessive mix leakage
into the long drip pan.
Models C708 & C716
PROBABLE CAUSE
a. Freezing cylinder not
primed correctly.
b. Air/mix pump incorrectly
assembled.
c. The viscosity control is set
too cold.
d. Freeze-up in mix inlet
hole.
e. Butterfat is in the pump.
a. Hopper cover is not in
position.
b. The agitator is not
installed.
c. The hopper temperature is
out of adjustment.
a. The hopper temperature is
out of adjustment.
a. Milkstone build-up in the
hopper.
a. The top o-ring on draw
valve is improperly
lubricated or worn.
a. Bottom o-ring on draw
valve is improperly
lubricated or worn.
a. Drive shaft seal improp-
erly lubricated or worn.
b. Drive shaft seal is
installed inside-out.
c. Inadequate lubrication of
the drive shaft.
d. The drive shaft and beater
assembly work forward.
e. Worn rear shell bearing.
f. Gear box out of alignment.
55
REMEDY
a. Drain the freezing cylinder
and reprime the machine.
b. Follow assembly
procedures carefully.
c. Call an authorized service
technician.
d. Call an authorized service
technician.
e. Disassemble, clean and
reinstall the pump.
a. Clean and sanitize hopper
cover and place in
position.
b. Clean and sanitize the
agitator and install.
c. Call an authorized service
technician.
a. Call an authorized service
technician.
a. Clean hoppers thoroughly.
a. Lubricate properly or
replace the o-ring.
a. Lubricate properly or
replace the o-ring.
a. Lubricate properly or
replace the seal.
b. Install correctly.
c. Lubricate properly.
d. Call an authorized service
technician.
e. Call an authorized service
technician.
f. Call an authorized service
technician.
Troubleshooting Guide
PAGE
REF.
44
39
- - -
- - -
39, 42, 49
45
45
- - -
- - -
50
38
38
33
33
33
- - -
- - -
- - -