Taylor C708 Operator's Manual page 29

Manager Menu Options
Touch the ARROW keys to move up or down
through the Menu. Select a Menu option by touching
the SEL key. Exit the Menu program by selecting
EXIT FROM MENU or touch the CONE key.
The following menu options are listed in the
Manager's Menu.
EXIT FROM MENU
SERVINGS COUNTER
SET CLOCK
AUTO HEAT TIME
AUTO START TIME
AUTO STANDBY TIME
AGITATOR OPERATION
MIX LEVEL AUDIBLE
FAULT DESCRIPTION
FAULT HISTORY
LOCKOUT HISTORY
HEAT CYCLE SUMMARY
HEAT CYCLE DATA
SYSTEM INFORMATION
CURRENT CONDITIONS
Exit From Menu
Selecting "EXIT FROM MENU" will exit the
Manager's Menu and the return the control panel
keys to normal operation.
Servings Counter
The SERVINGS COUNTER screen is used to check
or reset the number of servings dispensed from the
machine. The SERVINGS COUNTER will
automatically reset to zero when the machine is
brush cleaned.
SERVINGS COUNTER
Draws 0
> Next
Models C708 & C716
Reset the SERVINGS COUNTER by touching the
SEL key to advance to the next screen. Touch the
UP arrow key to move the arrow (>) to YES and
touch the SEL key. The servings counter will reset to
zero and exit back to the Manager's Menu.
RESET COUNTERS
ARE YOU SURE ?
> Yes
No
Set Clock
The SET CLOCK option allows the Manager to
adjust the control clock date and time. The date and
time may only be changed after the freezer has
been manually cleaned but before it has been
placed in the AUTO or STANDBY mode. The
following message will be displayed if the SET
CLOCK option is selected when the machine is not
in a brush clean state.
SET CLOCK
12:01 6/10/2010
NO CHANGES ALLOWED
Press Any Key
To change the date or time, select the SET CLOCK
option in the menu. Touch the UP arrow key to
advance the arrow from Exit to Change, then touch
the SEL key to select the Change option.
SET CLOCK
12:01 6/10/2010
Change
> Exit
Change the time by touching the UP arrow with the
cursor under the hour position. Move the cursor to
the minutes position by touching the SEL key. Once
the correct minutes are entered, touch the SEL key
to advance the cursor to the month.
SET CLOCK
12:01 6/10/2010
> Exit
25
150413
Important: To the Operator