Taylor C708 Operator's Manual page 58

PROBLEM
2. Hard lock message
appears on display.
3. No control panel functions
with power switch ON.
4. Machine makes a
squealing noise.
5. No product is being
dispensed.
6. The product is too soft.
Troubleshooting Guide
PROBABLE CAUSE
a. Brush clean interval
exceeded.
b. A barrel or hopper
thermistor is faulty.
a. Machine is unplugged.
b. Circuit breaker OFF or
blown fuse.
a. Starved barrel.
a. Low on mix. The MIX
OUT light is on.
b. The power switch is in the
OFF position.
c. Machine not in AUTO
mode.
d. Beater motor is out on
reset. The BEATER
OVERLOAD message
displayed.
e. The pump motor is not
running in the AUTO
mode.
f. Freeze-up in mix inlet
hole.
g. The mix pump ball crank
is broken.
h. Feed tube or check ring
not properly installed.
a. Draw rate is set too fast.
54
REMEDY
a. The freezer must be
disassembled and brush
cleaned within 24 hours
when the counter
indicates one day
remaining.
b. Call an authorized service
technician.
a. Plug into wall receptacle.
b. Turn the breaker ON or
replace the fuse.
a. Remove ,clean and
reinstall the pump.
a. Add mix to the hopper.
Return to AUTO mode.
b. Place the power switch to
ON and select AUTO.
c. Select AUTO and allow
machine to cycle off
before drawing product.
d. Turn the machine off.
Press the reset button.
Restart the machine in
AUTO.
e. Push the pump reset
button. Check pump motor
is operating when the
draw valve is raised.
f. Call an authorized service
technician.
g. Call an authorized service
technician.
h. Make sure feed tube and
rubber check ring are
properly installed.
a. Adjust draw rate of 5 to 7
1/2 oz. (142 g. to 213 g.)
of product by weight in 10
seconds.
Models C708 & C716
PAGE
REF.
22
- - -
- - -
- - -
39, 42, 49
44
43
44
- - -
19
- - -
- - -
41, 44
19