Taylor C708 Operator's Manual page 25

Power Switch OFF
After the safety timeout has been completed and the
power switch is OFF, the following screen is
displayed.
POWER SWITCH OFF
- = - = - = - = - = -
UNIT CLEANED
Power Switch ON
When the power switch is placed in the ON position,
the control panel touch keys become operative. The
fluorescent display will be either blank or indicate
that the unit has been cleaned.
UNIT CLEANED
International Models Only:
Some International models will continuously display
the temperature of the mix hopper when the power
switch is in the ON position.
HOPPER
UNIT CLEANED
If the control is set for international configuration, the
following screen will appear when the heat key is
touched.
ARE YOU SURE
> Yes
No
Models C708 & C716
21.0
Use the up or down arrow key to move the cursor to
"YES". Touch the SEL key to immediately start a
heat cycle.
Note: The machine must be in AUTO or STANDBY
and have sufficient mix in the hopper before the
machine can successfully enter the HEAT mode of
operation.
Heat Cycle
The HEAT key on the control panel is illuminated
throughout the heat treatment cycle. Two warning
messages will be displayed on the screen. "DO NOT
DRAW" will be displayed when the mix temperature
is below 130°F (54.4°C).
DO NOT DRAW
When the temperature of the mix is above 130°F
(54.4°C) the screen will display a message
indicating that HOT PRODUCT is in the machine.
HOT PRODUCT
DO NOT attempt to draw product or
disassemble the unit during the HEAT cycle. The
product is hot and under extreme pressure.
In the HEAT cycle, the mix temperature in the
hopper and freezing cylinder must be raised to
151°F (66.1°C) within 90 minutes.
When the heating phase is complete, the freezer
goes into the holding phase of the cycle. The holding
phase will keep the temperature above 151°F
(66.1°C) for a minimum of 35 minutes.
The final phase of the heat treatment cycle is the
cooling phase. The freezer must cool the mix below
41°F (5°C) within 90 minutes.
When the entire heat cycle has been completed, the
HEAT key will no longer be illuminated. The
machine will enter the STANDBY mode (STANDBY
key illuminates). The machine can be placed in
AUTO or left in STANDBY.
21
050628
Important: To the Operator