Taylor C708 Operator's Manual page 60

PROBLEM
14. The drive shaft is stuck in
the drive coupling.
15. The freezing cylinder
walls are scored.
16. The product makes a
popping sound when
drawn.
150623
Troubleshooting Guide
PROBABLE CAUSE
a. Mix and lubricant collected
in drive coupling.
b. Rounded corners of drive
shaft, drive coupling, or
both.
c. Gear box is out of
alignment.
a. Missing or worn front
bearing and beater shoes.
b. Scraper blades and/or
clips are damaged.
c. Unit was placed in AUTO
before all sanitizing
solution was removed
from freezing cylinder.
d. Broken freezer door baffle
rod.
e. Broken beater pins.
f. Beater assembly is bent.
g. Unit was placed in AUTO
before all sanitizing
solution was removed
from freezing cylinder.
h. Gear box is out of
alignment.
a. Draw rate is set too fast.
b. Pump assembled
incorrectly.
c. Freezing cylinder not
primed correctly.
56
REMEDY
a. Brush clean the rear shell
bearing area regularly.
b. Call an authorized service
technician.
c. Call an authorized service
technician.
a. Install or replace the front
bearing and beater shoes.
b. Replace scraper blades
and/or clips.
c. Place unit in AUTO only
after priming is complete
and all sanitizing solution
is removed.
d. Replace freezer door.
e. Replace beater assembly.
f. Replace beater assembly.
g. Place unit in AUTO only
after priming is complete
and all sanitizing solution
is removed.
h. Call an authorized service
technician.
a. Adjust draw rate of 5 to 7
1/2 oz. (142 g. to 213 g.)
of product by weight in 10
seconds.
b. Assemble and lubricate
according to instructions
in this manual.
c. Drain the freezing cylinder
and reprime the machine.
Models C708 & C716
PAGE
REF.
50
- - -
- - -
34, 37
34
43/ 44
37
34
34
43 / 44
- - -
19
39
44