JR Voyager E Assembly Instructions Manual page 29

CCPM SOFTWARE ACTIVATION AND INITIAL ADJUSTMENT (CONTINUED)
C) CCPM Settings
Turn the power switch on, then press the Up and Down keys simultaneously to enter the function mode. Press the Up key until "Swash Mix"
appears on the screen. Once this has been completed, it will be necessary to change the value of the aileron, elevator, and pitch functions from
the factory default setting using the + and - keys.
D) Servo Reversing
Press the Up key until "Rev. Sw." (Servo Reversing) appears on the screen. Next, reverse channels 3, 4, and 6 by moving the cursor with the
Channel key, then pressing the + or - keys.
E) Travel Adjustment
Press the Up key until "TRVL. ADJ." (travel adjust) appears on the screen. Adjust the values as shown using the channel key to move the
cursor, and the + and - keys to set the value. Press the Sel key to access the pitch channel values and set as indicated. Please note that the
required travel values will vary based on the type of servo selected. Please also note that the throttle travel values may vary based on the type
of engine used. This value can be fine tuned once the throttle linkage has been installed.
Digital Servos/Super Servos
[TRVL ADJ.]
£THRO
H 100%
L 100%
ELEV
D 120%
U 120%
Note: The travel values shown for the rudder function are for use with Piezo type gyros, like the JR NEJ-400 or NEJ-450 type gyros. If a
conventional mechanical type gyro is used (JR 120, 130, etc), then the travel values of the rudder channel will need to be reduced to
approximately 100%.
[SWASH MIX]
3servos
120 •
[REV.SW]
ch 1 2 3 4 5 6 7
REV.
NORM.
PIT.
AILE
£H 120%
£L 120%
L 120%
R 120%
AUX3
RUDD
£L 85% + 100%
- 100%
R 85%
AILE -50%
ELEV -50%
∞ PIT. +50%
REV NORM
THR
AIL
8
ELE
RUD
GER
PIT
Standard Servos
[TRVL ADJ.]
£THRO AILE
H 100% £L 100%
L 100% R 100%
ELEV RUDD
D 100% £L 70%
U 100% R
29
PIT.
£H 100%
L 100%
AUX3
+ 100%
- 100%
70%