JR Voyager E Assembly Instructions Manual page 28

CCPM SOFTWARE ACTIVATION AND INITIAL ADJUSTMENT (CONTINUED)
2. JR XP8103/XP8103DT SYSTEMS
The following activation and setup procedure should be used for all JR XP8103 and XP8103DT (digital trim) systems.
Note: Some early XP8103 systems will require the activation of the CCPM software through the Horizon service center. It's easy to identify if your
system has the CCPM function activated by identifying if the "SWASH TYP" function appears in the system mode as shown in Section A
below. Please refer to Section A to access the system mode.
Prior to activating the CCPM function, it is first suggested that the data reset function be performed to reset the desired model number to be
used back to the factory default settings.
Caution: Prior to performing the data reset function, it will be necessary to select the desired model number to be used.
A) Modal Selecte/Data Reset
Press the Up and Down keys simultaneously while turning the power switch on to enter the system mode. Next, press the Up or Down
keys to move the cursor to the model select function. Press the Up and Down keys simultaneously to enter the model select function.
Select the desired model number to be used, then press the Clear key to reset the current model to the factory default settings. Press the
Up and Down keys simultaneously to exit the model select function.
B) CCPM Activation
Press the Up or Down keys to move the cursor to the swash type function, then press the Up and Down keys simultaneously to access the
swashplate type function.
Press the Up or Down keys until "3 servo 120°" appears on the screen. Press the Up and Down keys simultaneously two times to exit the
swashplate type function and the system mode.
Note: If the swashplate type function is not present, it can be activated by the Horizon Service Center. Please call for details.
[SYSTEM M.]
• INFO-DISP • MODULAT
• Model SEL • TRANSFER
• MDL Name • INPUT SEL
• Type SEL • SWASH TYP
• MDL Reset
[SWASH TYP]
1servo
NORM
[MDL Reset]
MODEL 1
HELI SPCM
3 servos 120°
[SWASH TYP]
3servos
120 •
28