Table of Contents
Advertisement
5790B Calibration, Testing, and Diagnostics Commands
CAL_INTV?
Returns the calibration interval.
CAL_NEXT
Initiates the next calibration point.
Returns the value of the next point to be calibrated when in the middle of
CAL_NEXT?
calibrating a range.
Cancels any interactive calibration underway (that is, one started with the
CAL_OFF
CAL_AC, CAL_I2, or CAL_DC commands).
CAL_PASSWD
Changes the calibration passcode.
Returns a comma-separated-value format report similar to what is saved on a USB
CAL_RCSV?
flash drive.
CAL_RPT?
Returns a listing of a calibration report through the remote control port.
CAL_SECURE
Locks/unlocks calibration security.
CAL_SECURE?
Returns the lock state of calibration security.
CAL_SHIFT?
Returns the calibration shift for a single calibration point.
CAL_USB
Saves the calibration report to a USB flash drive.
Advances to the next step of an interactive procedure without executing the step
CAL_SKIP
(like a CAL_NEXT except the step is not executed).
CAL_SLST?
Returns the calibration shifts for a group of service calibration points.
Returns the uncertainty specification for a specified input value, range, and
CAL_SPEC?
frequency.
Lists the calibration constant groups that have been updated but not saved (and
CAL_STLST?
therefore, how many would be written to nonvolatile memory by a CAL_STORE
command with the same argument).
CAL_STORE
Stores calibration constants in the specified group list into nonvolatile memory.
Lists how many calibration constant groups have been modified but not saved (this
CAL_STORE?
is like CAL_STLST? except only the initial number is given).
Sets the ambient temperature value stored when a calibration procedure is done.
CAL_TEMP
Once set, the temperature is used for all calibration activities until changed.
CAL_TEMP?
Returns the recorded ambient temperature of calibration.
CAL_WBCABLE
Run the wideband cable calibration procedure.
CAL_WBLIN
Start the interactive wideband linearity calibration procedure.
CAL_WBLIH?
Lists the steps of the interactive wideband linearity calibration procedure.
CAL_ZERO
Executes internal dc zeros calibration.
CMDSTR?
Returns the command string that caused the last error.
Table 6-6. Command Summary (cont.)
Remote Commands
Use of *OPC?, *OPC, and *WAI
6
6-17
Advertisement
Table of Contents
